U Shaped Beam Road Weighbridge Truck Scale Type With 4 ~ 6mm Thickness Steel Plate

U-shaped Beam Steel Deck Weighbridge With 4 ~ 6mm Thickness Steel Plate

1. Our Sealed Frame Box structure’s scale body, the main features:

1) Upright U-shaped girder, the longitudinal beams with steel plate thickness 8mm, Girder height use 250,280,300,320mm

according to weighing capacity and special request ,Also,requires the selection of the middle two H-beam,which will be

higher strength and better performance.

Of course, the whole H-Shaped longitudinal beam is the best performance and longer life. Our Ushaped upright beam,

girders and ends with double-sided welding,so that form strong impact while heavy vehicle brakes,our welding beam

ends will not tear easily.

2) Inside the longitudinal direction of the scale body, addingδ6mm thick transverse ribs every 500mm, the middle scale body also has δ6mm high lateral full bars,like this way,transverse ribs and integrated lateral full bars will make each longitudinal beam bear force equally,in particular in the Middle scale body happens maximum deflection, so our design of lateral full bar with six beams forced,Reduce the scale body partial distortion,deformation,Thus,extending the life of the scale body.

3) Four-lane bottom sealed with steel plate which form a strong box shape, the bottom of scale body tensile strength

enhanced,better rigidity,greatly strengthen Girder bending capability.

2. Inclined U-shaped beam(Inverted trapezoidal U-shaped Beam)

Main Disadvantage:

With 4 ~ 6mm wall thickness steel plate girder only,scale body no internal lateral ribs,no bottom seal,only panel and six

Inverted trapezoidal beams forms scale body, diagonal lift is soft,anti-bias load is weak,no torsion,nor impact.

Because of Inverted trapezoidal beam single side welding,Steel girder plate is not upright,subject to Slam the brakes on

frequent overloading,And the girders by vertical force and the horizontal component,the horizontal component onto the

inclined welding to tear easily; if exist partial defect, beams will be quickly tear off the welding joint, resulting in beam

fracture, truck crush.Through market research,This accounts for the failure rate reached as high as 20%.

Another,due to thin girder plate,Terrible corrosion resistance,greatly effect on scale body using life,If take high frequency using,only 2-3 years,even 1 year period need to heavy maintenance.Details decide good or bad.

Customers should pay attention to the cost and quality choice.